Set a timer for twenty minutes and say the opening of your talk aloud. If you stumble, don’t spend the whole session polishing the first sentence. Save time for the transition you keep losing and for the last thing the audience needs to hear.
A practical example
For a ten-minute briefing, set aside twenty minutes and use a clock you can see while speaking. The aim is to find the part you need to change, not to deliver the same talk twice.
- Minutes 0 to 2: Find your opening. Say the first few sentences aloud. If you need a minute of background before the audience hears why they are there, try beginning with the decision or question instead.
- Minutes 2 to 12: Run the briefing. Stand or sit as you will on the day, advance your slides, and keep talking if you miss a word. When the ten minutes end, mark where you are. If you never reached the request, you have found a timing problem that faster talking is unlikely to solve.
- Minutes 12 to 17: Repair one rough spot. Cut a repeated example or practice a transition that gave you trouble. Say the sentence on each side of it aloud. “That is what the shorter booklet saves. Here is what we would leave out” makes a shift in the argument audible even to someone who cannot see the slide.
- Minutes 17 to 20: Land the ending. Start on the next-to-last slide and deliver the close. Name the decision or action, then stop. Note the one thing you still need to check, such as whether the chart is readable from the back of the room.
Giving a forty-minute talk? Use the ten-minute run for the hardest section and book a separate full-length rehearsal. Timing one section cannot tell you whether the whole talk fits. And if the projector or microphone is unfamiliar, arrange a room check rather than spending your only speaking practice on the equipment.
Treat the timing as a suggested routine
The twenty-minute plan below is a practical starting point, not a standard that every presentation must meet. A short briefing may need only one pass, while a longer talk may need several. Use the routine to create a habit, then adjust the steps to fit the length of your talk, the room, and the level of detail your audience expects.
If you have a fixed time limit, check your rehearsal against it. Going over the time allowed is a common problem, and a practice run is the best place to find where the extra minutes are going.
Rehearse the opening first
Begin by practicing the first two minutes. The opening should tell the audience why the topic matters and what they will gain from listening. Say it aloud, standing as you will in the room, without reading from notes. If you stumble, shorten the sentences rather than trying to recite them perfectly. A clear first minute is usually more valuable than a polished joke or a long introduction.
Record yourself if you can. Listen for whether the main point arrives early, and whether the audience has a reason to keep paying attention.
Time a full run
Once the opening feels steady, run the entire presentation from start to finish without stopping. Use a timer and do not correct yourself mid-sentence unless you lose the thread completely. Note where you ran long, where you rushed, and where a slide took more time to explain than you expected. A full run shows the rhythm of the talk, which a section-by-section practice cannot reveal.
Keep a simple record of the total time and the three longest sections. Those notes will guide the next revision more reliably than your memory of how the talk felt.
Practice the transitions
Many talks lose their audience between sections, not inside them. Practice the sentence that moves from one point to the next, and make sure it names the connection. For example, “That is the cost side. Now let’s look at what the change would save” tells listeners where the argument is heading. If a transition is hard to say, the connection between the sections may be weak, and the slides may need reordering.
Look at each slide during this step and ask whether it supports the sentence you just said. A slide that does not connect to the transition may be a candidate for removal.
Tighten the close
End with a short summary of the main message and one clear action or question. Rehearse the final thirty seconds until you know exactly how you will finish. Do not let the talk trail off with “that’s about it.” A deliberate close tells the audience that the presentation has reached its end, and it leaves them with the point you most want them to remember.
Check the environment and the equipment
During a practice session, test the same equipment you will use on the day. Confirm that the clicker, laptop, microphone, and display work, and that your slides open in the expected order. If the room has an unfamiliar layout, consider how far you will stand from the screen and whether you will need to face the audience while advancing slides. These details are small, but they can change your pace and confidence.







